Stateflow

Runtime Debugging

Once the target is built with the debugging code, you can then optionally enable or disable the associated runtime options in the Debugger. Enabling or disabling the options in the Debugger window affects the Debugger output display results. Enabling/disabling the options in the Debugger window affects the target code and can cause the target to be rebuilt when you start the simulation from the debugger.

There are also some runtime debugging options that do not require supporting code in the target. These options can be dynamically set:

• Enable/disable cycle detection in the Debugger window
• Set global breakpoints at:
• Any chart entry
• Any event broadcast
• Any state entry
• Enable/disable local Debugger breakpoints at specific chart or state action execution points in these appropriate property dialog boxes:
• Chart (see Specifying Chart Properties)
• State (see Changing Event Properties)
• Enable/disable local Debugger breakpoints at a specific transition (either when the transition is tested or when it is determined to be valid) in the Transition property dialog box (see Using the Transition Properties Dialog)
• Enable/disable local Debugger breakpoints based on a specific event broadcast (see Event Dialog Box)

Breakpoints

Stateflow Debugger User Interface