Using Simulink    

Using the Debugger's Command-Line Interface

In command-line mode, you control the debugger by entering commands at the debugger command line in the MATLAB command window. The debugger accepts abbreviations for debugger commands. See Debugger Command Reference for a list of command abbreviations and repeatable commands. You can repeat some commands by entering an empty command (i.e., by pressing the Return key) at the MATLAB command line.

About Block Indexes

Many Simulink debugger commands and messages use block indexes to refer to blocks. A block index has the form s:b where s is an integer identifying a system in the model being debugged and b is an integer identifying a block within that system. For example, the block index 0:1 refers to block 1 in the model's 0 system. The slist command shows the block index for each block in the model being debugged (see slist).

Accessing the MATLAB Workspace

You can type any MATLAB expression at the sldebug prompt. For example, suppose you are at a breakpoint and you are logging time and output of your model as tout and yout. Then, the following command

creates a plot. Suppose you would like to access a variable whose name is the same as the complete or incomplete name of an sldebug command, for example, s, which is a partial completion for the step command. Typing an s at the sldebug prompt steps the model However,

displays the value of the variable s.


 Starting the Simulation Getting Online Help