Using Simulink

Creating an Enabled Subsystem

You create an enabled subsystem by copying an Enable block from the Signals & Systems library into a subsystem. Simulink adds an enable symbol and an enable control input port to the Subsystem block icon.

Setting Output Values While the Subsystem Is Disabled

Although an enabled subsystem does not execute while it is disabled, the output signal is still available to other blocks. While an enabled subsystem is disabled, you can choose to hold the subsystem outputs at their previous values or reset them to their initial conditions.

Open each Outport block's dialog box and select one of the choices for the Output when disabled parameter, as shown in the dialog box below:

• Choose held to cause the output to maintain its most recent value.
• Choose reset to cause the output to revert to its initial condition. Set the Initial output to the initial value of the output.
  
  

Setting States When the Subsystem Becomes Re-enabled

When an enabled subsystem executes, you can choose whether to hold the subsystem states at their previous values or reset them to their initial conditions.

To do this, open the Enable block dialog box and select one of the choices for the States when enabling parameter, as shown in the dialog box below:

• Choose held to cause the states to maintain their most recent values.
• Choose reset to cause the states to revert to their initial conditions.

Outputting the Enable Control Signal

An option on the Enable block dialog box lets you output the enable control signal. To output the control signal, select the Show output port check box.

This feature allows you to pass the control signal down into the enabled subsystem, which can be useful where logic within the enabled subsystem is dependent on the value or values contained in the control signal.

Enabled Subsystems

Blocks an Enabled Subsystem Can Contain