Report Generator

Adding, Replacing, and Deleting Properties to a Table Cell

The following sections discuss how to add, replace, and delete properties to a table cell.

Adding a Property

To add a Handle Graphics property to a table cell in the Setup File Editor, follow these steps:

1. Select the desired table cell.
2. Choose the type of property from the type of property drop box on the right side of the attributes page. The type of property drop box acts like a filter by listing properties by category.

If you want to choose from all properties associated with a Handle Graphics figure, choose All properties in the type of property drop box.

3. Choose the desired property name from the property list box.
4. Double-click on the property name or use the Add button.

If you know the name of the property, you can also type the property name in the cell. See Putting Text in a Table Cell in the previous section.

Note    The attribute page in the Setup File Editor does not display text wrapping inside a cell, but when the report is created, the text inside a cell will wrap.

Replacing or Deleting Properties

In the non-split mode, you can replace a property in a table cell in the Setup File Editor by following the instructions in Putting Text in a Table Cell. You can delete a property by backspacing over it.

To replace a Handle Graphics property in a cell when the table is in split mode, follow the instructions in Adding a Property. You cannot use these steps to delete a Handle Graphics property in a cell when the table is in non-split mode, since a cell can have more than one property name/property value pair.

Title

Displaying or Hiding Table and Cell Borders