xPC Target | ![]() ![]() |
CIO-DIO96 Digital Output
The CIO-DIO96 has four 8255 chips (1,2,3,4). Each chip has three ports (A,B,C). Each port has a maximum of 8 digital I/O lines that can be configured as inputs or outputs.
Use a separate diver block for each port. By selecting the digital output driver block, the port is configured as output.
Scaling Input to Output
Hardware Output |
Block Input Data Type |
Scaling |
TTL |
double |
< 0.5 = TTL low > 0.5 = TTL high |
Driver Block Parameters
Channel Vector - Enter numbers between 1 and 8 to select the digital output lines used with this port. This driver allows the selection of individual digital output lines in any order. The number of elements defines the number of digital lines used.
For example, to use all of the digital outputs for one port, enter
[1,2,3,4,5,6,7,8]
Number the lines beginning with 1 even if the board manufacture starts numbering the lines with 0.
Port - From the list choose either A, B, or C. The I/O board has two 8255 chips with 3 ports. The Port parameter defines which port of the 8255 chip is used for this driver block. Each port has a maximum or 8 digital lines that can be configured as inputs or outputs depending on which driver block is chosen. In each case, one block is needed for each port.
Chip - From the list choose 1, 2, 3, or 4. The Chip parameter defines which of the four 8255 chips is used.
Sampletime - Enter a base sample time or a multiple of the base sample time.
BaseAddress - Enter the base address of the board. This entry must corresponds to the DIP-switch settings on the board. For example, if the base address is 300 (hexadecimal), enter
0x300
![]() | CIO-DIO96 Digital Input | CIO-DIO192 | ![]() |