xPC Target | ![]() ![]() |
CIO-DAS1602/12 Analog Output (D/A)
Scaling Input to Output
Hardware Output |
Block Input Data Type |
Scaling |
volts |
double |
1 |
Driver Block Parameters
Channel Vector - Enter Numbers between 1 and 2. This driver allows the selection of individual D/A channels in any order. The number of elements defines the number of D/A channels used. For example, to use the first and second analog output (D/A) channels, enter
[1,2]
Number the channels beginning with 1 even if the board manufacturer starts numbering the channels with 0.
Range Vector - Enter a range code for each of the channels in the channel vector. The range vector must be the same length as the channel vector. This board allows the range of each channel to be different.
The following table is a list of the ranges for this driver and the corresponding range codes.
Input range (V) |
Range code |
Input range (V) |
Range code |
-10 to +10 |
-10 |
0 - 10 |
10 |
-5 to +5 |
-5 |
0 - 5 |
5 |
For example, if the first channel is -10 to +10 volts, and the second channel is 0 to 5 volts, enter
[-10,5]
The range settings have to correspond to the DIP-switch settings on the board. Also the Bipolar/ Unipolar jumpers have to be planted according to the ranges used.
Sampletime - Base sample time or a multiple of the base sample time.
BaseAddress - Enter the base address of the board. It is important that this entry corresponds to the DIP-switch settings on the board. For example, if the base address is 300 (hexadecimal), enter
0x300
![]() | CIO-DAS1602/12 Analog Input (A/D) | CIO-DAS1602/12 Digital Input | ![]() |