xPC Target    

Target Boot Disk

You use the target boot disk to load and run the xPC Target kernel

After you make changes to the xPC Target environment properties, you need to create or update a target boot disk.

To create a target boot disk for the current xPC Target environment, use the procedure below:

  1. In the MATLAB window, type

    The xPC Target Setup window opens.

  1. Click the BootDisk button.

    If you didn't update the current settings, the following message box opens.

    Click No. Click the Update button, and then click the BootDisk button again.

    After you update the current properties, and click the BootDisk button, the following message box opens.

  1. Insert a formatted 3 1/2 inch floppy disk into the host PC disk drive, and then click OK.

    Note All data on the disk will be erased.

    xPC Target displays the following dialog box while creating the boot disk. The process takes about 1 to 2 minutes.

  1. Close the xPC Target Setup window.
  2. Remove the target boot disk from the host PC disk drive and insert it into your target PC disk drive.

Your next task is to test your installation. See Testing and Troubleshooting the Installation.


 Environment Properties for Network Communication Current Properties on the Target Boot Disk